These pages are intended to display aspects of my activities and to highlight items on which I would appreciate help.
The first challenge is to fit Dingham couplings to one end of each of these to use as links for my wagons that may run on my club's new layout: I use 3 link but the club has standardised on Dinghams.
Here's a model that is a good demonstration of success and failure. The boiler fittings were my first attempt at 3D printing and I was pleased with the results. The chassis was my second attempt at outside frames and CSBs and was a failure: it was too wide over the crankpins and I managed to get superglue in the bearings! A new chassis is under construction.